Sanyo PLC-XF31N Projector User Manual


 
8
PREPARATION
SETTING-UP PROJECTOR
This projector uses nominal input voltages of 100-120 V
or 200-240 V AC. This projector automatically selects
correct input voltage. It is designed to work with single-
phase power systems having a grounded neutral
conductor. To reduce risk of electrical shock, do not plug
into any other type of power system.
Consult your authorized dealer or service station if you
are not sure of type of power supply being in use.
Connect a projector with a peripheral equipment before
turning a projector on. (Refer to pages 12 ~ 15 for
connection.)
CONNECTING AC POWER CORD
Connect AC Power Cord (supplied) to
a projector.
AC outlet must be near this equipment
and must be easily accessible.
To POWER CORD
CONNECTOR on your
projector.
Projector side AC Outlet side
Ground
NOTE ON POWER CORD
AC Power Cord must meet requirement of country where you use a projector.
Confirm an AC plug type with chart below and proper AC power cord must be used.
If supplied AC Power Cord does not match your AC outlet, contact your sales dealer.
To AC Outlet.
(120 V AC)
For Continental Europe
For the U.S.A. and Canada
For the U.K.
To AC Outlet.
(200 - 240 V AC)
To AC Outlet.
(200 - 240 V AC)