Filter
Top Products
9
Part Names and Functions
Part Names and Functions
Part Names and Functions
Rear Terminal
q w e r t y
i
u
✽
o
r COMPUTER IN 2 / MONITOR OUT
This terminal is switchable and can be
used for input from a computer and video
equipment (component or RGB scart
21-pin) or output to the other monitor.
Set the terminal up as either Computer
input or Monitor output properly. (Used
for Monitor out, this terminal outputs only
incoming signal from COMPUTER IN 1/
COMPONENT IN terminal.) (p15, 17, 46)
q USB (Series B)
In order to operate the computer with
the remote control during a presentation,
connect the USB port of the computer to the
projector with a USB cable. (p.15)
w SERVICE PORT
This jack is used to service the projector.
e COMPUTER IN 1/COMPONENT IN
Connect output signal from a computer,
RGB scart 21-pin video output, or
component video output to this terminal.
(p.15, 17)
When the cable is of the longer variety, it
is advisable to use this terminal and not
COMPUTER IN 2/MONITOR OUT.
RESET button
A built-in micro processor which controls this
unit may occasionally malfunction and need
to be reset. This can be done by pressing
the RESET button with a pen, which will
shut down and restart the unit. Do not use
the RESET function excessively.
t S-VIDEO IN
Connect the S-VIDEO output from video
equipment to this jack. (p.16)
y AUDIO IN
Connect the audio output from video
equipment connected to t or o to this
jack. (When the audio output is monaural,
connect it to L (MONO) jack.) (p.16)
i COMPUTER/ COMPONENT AUDIO IN
Connect the audio output (stereo) from a
computer or video equipment connected to
e or r to this jack. (p 15, 17)
o VIDEO IN
Connect the composite video output from
video equipment to VIDEO jack. (p.16)
u AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this
jack. (p.15 - 17)
This terminal outputs sound from AUDIO IN
terminal (y or i).
✽