Sanyo PLC-ZM5000 Projector User Manual


  Open as PDF
of 92
 
This projector uses nominal input voltages of 100–240 V
AC and it automatically selects the correct input voltage.
It is designed to work with single-phase power systems
having a grounded neutral conductor. To reduce the risk of
electrical shock, do not plug into any other type of power
system.
If you are not sure of the type of power being supplied,
consult your authorized dealer or service center.
Connect the projector with all peripheral equipment before
turning on the projector.
Installation
NOTE ON THE POWER CORD
AC power cord must meet the requirements of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If the supplied AC power cord does not match your AC outlet, contact your sales dealer.
Projector side AC Outlet side
To POWER CORD
CONNECTOR on
your projector.
Ground
To the AC Outlet.
(120 V AC)
For Continental Europe
For the U.S.A. and Canada
For the U.K.
To the AC Outlet.
(200–240 V AC)
To the AC Outlet.
(200–240 V AC)
Note:
UnplugtheACpowercordwhentheprojectorisnotin
use.Whentheprojectorisconnectedtoanoutletwith
ACpowercord,itisinstand-bymodeandconsumesa
littleelectricpower.
CAUTION
The AC outlet must be near this equipment and must be
easily accessible.
Basic Operation
Connecting the AC Power Cord
Connect the AC power cord (supplied)
to the projector.
Ground
22
 previous next