Sanyo VM-6612 Computer Monitor User Manual


 
PARTS NAMES
Rear Panel
1 AC input socket (AC INPUT)
Connect the AC power cord (supplied) securely to this
socket and to a wall outlet.
2 Video input terminals (VIDEO IN)
These terminals are used to input a video signal
source to this monitor.
Connect to the video output of a VCR or another
monitor (for loop through connection) or to a video
camera.
3 Video output terminals (VIDEO OUT)
These terminals are used to output a video signal
from this monitor.
Loop-through output of the video in BNC connector,
then connect to the video input of another monitor or
a VCR.
4 Termination Switch (HI/75 (Lo))
Select the input impedance (HI/75).
When using only one monitor, turn the termination
switch to the 75 position. When using more than
one monitor, set all of the termination switch on the
monitors to the HI position. However, the last monitor
termination switch should be in the 75 position for
proper line termination.
5 Sub-brightness control (SUB-BRI)
Turn to adjust picture brightness.
6 Vertical Size control (V-SIZE)
Turn to adjust picture vertical size of the picture.
7 Vertical hold control (V-HOLD)
If the picture is scrolling up or down on the screen,
turn this control until there is a single steady picture.
VM-6609 VM-6614
VM-6619
1456
142 576
14256
VM-6612
142 576
2
3
3
3
3
L8MAA/US (VMC-6609, 6612, 6615, 6620 GB) 2000. 11. 21
5