Filter
Top Products
• 4 •
Appliance Type Estimated
Wattage
Estimated Time
for IP-95C
Estimated Time
for IP-125C
Electrical Tools 24 Watts 4 Hours 5 Hours
Electrical Coolers 48 Watts 1.5 Hours 2 Hours
Car Vacuum,
Air Compressors
80 Watts 45 Minutes 1 Hour
NOTE: Estimated run-times. Actual time may vary. Times are based on the
internal battery being fully charged.
The DC accessory outlet has a 15-amp automatic overload protection
circuit breaker. If an overload occurs, unplug (remove) accessory, and the
breaker will automatically reset.
USING USB PORT8.
NOTE: The Jump Start + USB On/Off switch energizes both the jump
starting clamps and the USB port. Do not allow the clamps to touch each
other or the same piece of metal when the switch is “On” (turned to the
right).
Conrm both jump starting clamps are stored on the storage holders.8.1
Turn the Jump Start + USB switch to “On” position.8.2
The USB plug is now live; plug in the accessory.8.3
USING THE AIR COMPRESSOR9.
PRECAUTION – Read instructions of the product being inated before
using the compressor. Avoid over ination, do not exceed the manufactur-
ers recommended pressures. DO NOT leave the compressor unattended
during use.
The 12 volt compressor is rated for 150 PSI pressure. The hose is stored
on the back of your Instant Power™.
The ON / OFF switch for the compressor is located on the back of the
Instant Power™.
Attach the air compressor hose to the product or accessory to be inated 9.1
by ipping down the lever.
Push the air compressor switch to the ON position and inate product.9.2
When the product is inated to the proper air pressure, push the compres-9.3
sor switch to the OFF position and remove the hose.
Do not run compressor for more than 10 minutes maximum at a time. Al-9.4
low to cool down for 10 minutes before using again.