Filter
Top Products
4004041 Rev C 45
Having Difficult
y
?
Q. How does the cable modem connect to my computer?
A. The cable modem connects to the USB port or the 10/100BaseT Ethernet port on
your PC. If your PC is not equipped with an Ethernet interface, an Ethernet card is
available from your local PC or office supply retailer, or from your cable service
provider.
Q. After my cable modem is connected, how do I access the Internet?
A. Your local service provider becomes your Internet Service Provider (ISP). They
offer a wide range of services including e-mail, chat, news, and information services.
Your cable service provider will provide the software you will need.
Q. Can I watch TV and surf the Internet at the same time?
A. Absolutely! If you subscribe to cable television service, you can watch TV and
use your cable modem at the same time by connecting your TV and your cable
modem to the cable network using an optional cable signal splitter.
Q. Can I run more than one device on the modem?
A. Yes. A single cable modem will theoretically support up to 253 Ethernet devices
utilizing user-supplied Ethernet hubs or routers that you can purchase at your local
PC or office supply retailer. Another user at your location can simultaneously
connect to the USB port on the cable modem. Contact your service provider for
further assistance.
Common Troubleshooting Issues
I don't understand the front panel status indicators
See Front Panel LED Status Indicator Functions, for more detailed information on
front panel LED status indicator operation and function.
The modem does not register an Ethernet connection
Verify that your computer has an Ethernet card and that the Ethernet driver
software is properly installed. If you purchase and install an Ethernet card,
follow the installation instructions very carefully.
Verify the status of the front panel LED status indicators.
The modem does not register an Ethernet connection after connecting to a hub
If you are connecting multiple PCs to the cable modem, you should first connect the
modem to the uplink port of the hub using the correct crossover cable. The LINK
LED of the hub will illuminate continuously.