Filter
Top Products
Constellation CS Serial ATA Product Manual, Rev. C 24
www.seagate.com
3.4 Drive mounting
You can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-
mounting holes. Refer to Figure 7 for drive mounting dimensions. Follow these important mounting precautions when
mounting the drive:
• Allow a minimum clearance of 0.030 inches (0.76mm) around the entire perimeter of the drive for cooling.
• Use only 6-32 UNC mounting screws.
• The screws should be inserted no more than 0.150 inch (3.81mm) into the bottom or side mounting holes.
• Do not overtighten the mounting screws (maximum torque: 6 inch-lb).
Figure 7 Mounting dimensions
Weight: (maximum) 3TB models 2TB models 1TB models
626g (1.38 lb) 535g (1.18 lb) 400g (0.88 lb)
Note
These dimensions conform to the Small Form Factor Standard documented
in SFF-8301 and SFF-8323 found at
www.sffcommittee.org
Breather
Hole
mm
in
mm
in
mm
in
1TB model height
2 & 3TB model height