Filter
Top Products
PULSAR.2 SAS PRODUCT MANUAL, REV. C 47
11.3.1 INQUIRY data
Table 17 lists the INQUIRY command data that the drive should return to the initiator per the format given in the SAS Interface Manual.
Table 17 Pulsar.2 INQUIRY data
BYTES DATA (HEX)
0-15 00 00 xx** 12 8B 01 PP 02 53 45 41 47 41 54 45 20 Vendor ID
16-31 [53 54 38 30 30 46 4D 30 30 30 32] 20 20 20 20 20 Product ID
32-47 R# R# R# R# S# S# S# S# S# S# S# S# 00 00 00 00
48-63 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
64-79 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
80-95 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
96-111 00 43 6F 70 79 72 69 67 68 74 20 28 63 29 20 32* *Copyright
112-127 30* 31* 31* 20 53 65 61 67 61 74 65 20 41 6C 6C 20 notice
128-143 72 69 67 68 74 73 20 72 65 73 65 72 76 65 64 20
* Copyright year (changes with actual year).
** SCSI Revision support. See the appropriate SPC release documentation for definitions.
PP 10 = INQUIRY data for an INQUIRY command received on Port A.
30 = INQUIRY data for an INQUIRY command received on Port B.
R# Four ASCII digits representing the last four digits of the product firmware release number.
S# Eight ASCII digits representing the eight digits of the product serial number.
[ ] Bytes 16 through 26 reflect model of drive. The table above shows the hex values for Model ST800FM0002.
Refer to the values below for the values of bytes 16 through 26 for a particular model:
ST800FM0012 53 54 38 30 30 46 4D 30 30 31 32
ST800FM0022 53 54 38 30 30 46 4D 30 30 32 32
ST800FM0032 53 54 38 30 30 46 4D 30 30 33 32
ST800FM0042 53 54 38 30 30 46 4D 30 30 34 32
ST400FM0002 53 54 34 30 30 46 4D 30 30 30 32
ST400FM0042 53 54 34 30 30 46 4D 30 30 34 32
ST200FM0002 53 54 32 30 30 46 4D 30 30 30 32
ST200FM0042 53 54 32 30 30 46 4D 30 30 34 32
ST100FM0002 53 54 31 30 30 46 4D 30 30 30 32
ST100FM0052 53 54 31 30 30 46 4D 30 30 35 32