Filter
Top Products
Barracuda 4 Installation Guide, Rev. E 35
Setting the SCSI ID jumpers
Use the J4 connector to set the SCSI ID (Figure 10). To
change the SCSI ID, install jumpers on the appropriate
pins as shown in the illustration.
Figure 10. Setting the SCSI ID
SCSI ID = 0 (default)
SCSI ID = 7
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
J4
ID2
ID1
ID0
Select SCSI ID by placing
j
umpers as shown below.
SCSI
Connector
DC Power
Connector
J4
Pin 1
N/ND drives