Filter
Top Products
Momentus Thin Product Manual, Rev. C Gen-2 5
*One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment
and formatting.
**During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and
power to operational levels.
***Typical notebooks will pull power to the drive when entering S3 and S4; while in the S3 and S4 states, drive sleep and drive standby
modes will not contribute to battery power consumption.
Read/write power (typical) Read: 1.6W; Write: 1.9W
Idle mode, low power (typical) 0.66W
Standby/Sleep mode (typical) 0.15W ***
Voltage tolerance (including noise) +5V ± 10%
Ambient temperature 0° to 60°C (operating), –40° to 70°C (nonoperating)
Temperature gradient
(°C per hour max)
20°C (operating)
35°C (nonoperating)
Relative humidity 5% to 95% (operating)
5% to 95% (nonoperating)
Relative humidity gradient 30% per hour max
Wet bulb temperature
(°C max)
37.7 (operating)
40 (nonoperating)
Altitude, operating –304.8 m to 3,048 m (–1000 ft. to 10,000
+ ft.)
Altitude, nonoperating
(meters below mean sea level, max)
–304.8 m to 12,192 m (–1000 ft. to 40,000
+ ft.)
Shock, operating (Gs max at 2ms) 350
Shock, nonoperating (Gs max at 2ms) 800
Shock, nonoperating (Gs max at 1ms) 1000
Shock, nonoperating (Gs max at 0.5ms) 600
Vibration, operating (Swept Sine) 1.0 Gs (0 to peak, 5–500 Hz)
Vibration, nonoperating 5.0 Gs (0 to peak, 5–500 Hz)
Drive acoustics, sound power (bels)
Idle** 2.3 (typical)
2.5 (max)
Seek 2.5 (typical)
2.7 (max)
Nonrecoverable read errors 1 per 10
14
bits read
Annualized Failure Rate (AFR) 0.50%
Load/Unload (U/UL) cycles
25°C, 50% relative humidity
32°C, 80% relative humidity
5°C, 80% relative humidity
5°C, 10% relative humidity
55°C, 16% relative humidity
600,000 software-controlled power on/off cycles
20,000 hard power on/off cycles
600,000 software-controlled power on/off cycles
20,000 hard power on/off cycles
Warranty To determine the warranty for a specific drive, use a web browser to access the following
web page: http://www.sea
gate.com/www/en-us/support/warranty_&_returns_assistance
You will be asked to provide the drive serial number, model number (or part number)
and country of purchase. After submitting this information, the system will display the
warranty information for your drive.
Supports Hotplug operation per Serial ATA
Revision 2.6 specification
Yes (requires COMRESET from host after a hotplug event)
Table 1: Drive specifications
Drive specification
ST320LT007 - 9ZV142
ST320LT009 - 9WC142
ST320LT011 - 9ZVG42
ST320LT014 - 9YK142
ST250LT007 - 9ZV14C
ST250LT009 - 9WC14C
ST250LT011 - 9ZVG4C
ST250LT014 - 9YK14C
ST160LT007 - 9ZV14D
ST160LT009 - 9WC14D
ST160LT011 - 9ZVG4D
ST160LT014 - 9YK14D