Filter
Top Products
Seagate Desktop SSHD Product Manual, Rev. C 13
www.seagate.com Drive Specifications
2.13 Agency certification
2.13.1 Safety certification
These products are certified to meet the requirements of UL60950-1, CSA60950-1 and EN60950 and so marked
as to the certify agency.
2.13.2 Electromagnetic compatibility
Hard drives that display the CE mark comply with the European Union (EU) requirements specified in the
Electromagnetic Compatibility Directive (2004/108/EC) as put into place 20 July 2007. Testing is performed to the
levels specified by the product standards for Information Technology Equipment (ITE). Emission levels are defined
by EN 55022, Class B and the immunity levels are defined by EN 55024.
Drives are tested in representative end-user systems. Although CE-marked Seagate drives comply with the
directives when used in the test systems, we cannot guarantee that all systems will comply with the directives.
The drive is designed for operation inside a properly designed enclosure, with properly shielded I/O cable (if
necessary) and terminators on all unused I/O ports. Computer manufacturers and system integrators should
confirm EMC compliance and provide CE marking for their products.
Korean RRL
If these drives have the Korean Communications Commission (KCC) logo, they comply with paragraph 1 of Article
11 of the Electromagnetic Compatibility control Regulation and meet the Electromagnetic Compatibility (EMC)
Framework requirements of the Radio Research Laboratory (RRL) Communications Commission, Republic of
Korea.
These drives have been tested and comply with the Electromagnetic Interference/Electromagnetic Susceptibility
(EMI/EMS) for Class B products. Drives are tested in a representative, end-user system by a Korean-recognized
lab.
• Family name: Desktop SSHD
• Certificate number: in process
Australian C-Tick (N176)
If these models have the C-Tick marking, they comply with the Australia/New Zealand Standard AS/NZ CISPR22
and meet the Electromagnetic Compatibility (EMC) Framework requirements of the Australian Communication
Authority (ACA).
2.13.3 FCC verification
These drives are intended to be contained solely within a personal computer or similar enclosure (not attached as
an external device). As such, each drive is considered to be a subassembly even when it is individually marketed
to the customer. As a subassembly, no Federal Communications Commission verification or certification of the
device is required.
Seagate has tested this device in enclosures as described above to ensure that the total assembly (enclosure,
disk drive, motherboard, power supply, etc.) does comply with the limits for a Class B computing device, pursuant
to Subpart J, Part 15 of the FCC rules. Operation with non-certified assemblies is likely to result in interference to
radio and television reception.
Radio and television interference. This equipment generates and uses radio frequency energy and if not
installed and used in strict accordance with the manufacturer’s instructions, may cause interference to radio and
television reception.
This equipment is designed to provide reasonable protection against such interference in a residential installation.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause interference to radio or television, which can be determined by turning the equipment on and off, users are
encouraged to try one or more of the following corrective measures:
• Reorient the receiving antenna.
• Move the device to one side or the other of the radio or TV.
• Move the device farther away from the radio or TV.
• Plug the computer into a different outlet so that the receiver and computer are on different branch outlets.