Filter
Top Products
26 Barracuda 2LP Installation Guide, Rev. E
Mounting the drive and connecting cables
Do not touch the connector pins or any components on
the control board without observing static-discharge pre-
cautions. Always handle the drive by the frame only.
The drive may be mounted in any orientation (horizon-
tally, vertically, and any combination thereof); however,
you must ensure that the drive receives adequate air flow
for cooling.
1. Mount the drive to the host system’s chassis using four
6-32 UNC screws. Two mounting holes are in each
side of the drive and there are four mounting holes in
the bottom of the drive.
The maximum length that the screws should extend
into the chassis mounting holes is 0.15 inch (3.81
mm), measured from the outer surface of the chassis.
Tighten the screws down evenly. Do not over-tighten
or force the screw if it does not seem to screw in easily,
because this means the threads are not properly
aligned. In this case, back the screw out and try again.