Seagate ST33000652NS Laptop User Manual


 
CONSTELLATION ES.2 SERIAL ATA PRODUCT MANUAL, REV. H 37
6.3.2 Set Features command
This command controls the implementation of various features that the drive supports. When the drive receives this command, it sets
BSY, checks the contents of the Features register, clears BSY and generates an interrupt. If the value in the register does not represent a
feature that the drive supports, the command is aborted. Power-on default has the read look-ahead and write caching features enabled.
The acceptable values for the Features register are defined as follows:
Note. At power-on, or after a hardware or software reset, the default values of the features are as indicated above.
Table 8 Set Features command values
02
H
Enable write cache (default).
03
H
Set transfer mode (based on value in Sector Count register).
Sector Count register values:
00
H
Set PIO mode to default (PIO mode 2).
01
H
Set PIO mode to default and disable IORDY (PIO mode 2).
08
H
PIO mode 0
09
H
PIO mode 1
0A
H
PIO mode 2
0B
H
PIO mode 3
0C
H
PIO mode 4 (default)
20
H
Multiword DMA mode 0
21
H
Multiword DMA mode 1
22
H
Multiword DMA mode 2
40
H
Ultra DMA mode 0
41
H
Ultra DMA mode 1
42
H
Ultra DMA mode 2
43
H
Ultra DMA mode 3
44
H
Ultra DMA mode 4
45
H
Ultra DMA mode 5
46
H
Ultra DMA mode 6
10
H
Enable use of SATA features
55
H
Disable read look-ahead (read cache) feature.
82
H
Disable write cache
90
H
Disable use of SATA features
AA
H
Enable read look-ahead (read cache) feature (default).
F1
H
Report full capacity available