Filter
Top Products
68
NL35 Series FC Product Manual, Rev. D
9.6.2 LED driver signals
Fault and Active LED signals are located in the FC-SCA connector (J1). See Table 35 for the output character-
istics of the LED drive signals.
9.6.3 Differential PECL output
The serial PECL output signal voltage characteristics are provided in Table 36. The outputs are not AC coupled
in order to deliver maximum signal without rise and fall time degradation. You must AC couple the receiver to
isolate potentially different DC characteristics of the outputs and the receiver.
Figure 12 provides the data output valid eye diagram relative to the bit cell time. Table 38 lists the data values.
Figure 12. Transmit eye diagram
9.6.4 Differential PECL input
The serial PECL input signal voltage characteristics are provided in Table 37.
Table 35: LED drive signal
State Current drive available Output voltage
LED off, high 0 < I
OH
< 100µA
LED on, low I
OL
< -30 mA 0 < V
OL
< 0.8V
Table 36: Differential PECL output characteristics
Description Parameter
Serial output voltage swing 600 < V
out
< 1300 mV
Table 37: Differential PECL input characteristics
Description Parameter Notes
Serial input voltage swing 400 < V
in
< 2.000 mV AC coupled
Bit Time
Vout (mv)
XMIT Eye