Seagate ST34502LW/LC Computer Drive User Manual


 
Cheetah 9LP Installation Guide, Rev. B 19
Initial setup information
The general information beginning on this page applies to all of
the Cheetah 9LP drive models. After reading the general infor-
mation topics, refer to the appropriate drive-specific section
listed below for additional information about configuring and
installing your particular model.
Drive models Page
ST39102LW and ST34502LW 40
ST39102LC and ST34502LC 46
General information
The following general information topics are discussed:
Single-ended and low voltage differential modes
SCSI ID jumpers
Drive termination
Terminator power
Interface drivers and data path width notes
Other applicable jumper options
Providing adequate cooling
Mounting the drive and connecting cables
1
Formatting the drive
1
This mounting procedure does not apply to “LC” model drives.
To mount an “LC” drive, plug the drive into the system’s single
connector attachment (SCA) position on the system’s back
panel.