Filter
Top Products
SEAGATE LAPTOP SSHD SATA PRODUCT MANUAL, REV. D 8
DRIVE SPECIFICATIONS
2.7.1.1 Typical current profiles
The typical 5V startup and operation current profile is shown in Figure 1.
Figure 1 Typical 5V Startup and Operation Current Profile
2.7.2 Conducted noise
Input noise ripple is measured at the host system power supply across an equivalent 15-ohm resistive load on the +5 volt line.
Using 5-volt power, the drive is expected to operate with a maximum of 100 mV peak-to-peak square-wave injected noise at up to 10
MHz.
NOTE
Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write current.
2.7.3 Voltage tolerance
Voltage tolerance (including noise):
+5V ± 5%