![](http://pdfasset.owneriq.net/c/80/c8014876-25ed-457f-b60f-9e0c1503fde2/c8014876-25ed-457f-b60f-9e0c1503fde2-bg1b.png)
Momentus 5400.4 SATA Product Manual, Rev. B (Draft 02)
19
3.4 Drive mounting
You can mount the drive using four screws in the side-mounting holes or four screws in the bottom-mounting
holes. See Figure 4 for drive mounting dimensions. Follow these important mounting precautions when mount-
ing the drive:
• Allow a minimum clearance of 0.030 inches (0.76 mm) around the entire perimeter of the drive for cooling.
• Use only M3 UNC mounting screws.
• Do not overtighten the mounting screws (maximum torque: 4.0 inch-lb).
• Four (4) threads (0.080 inches) minimum screw engagement recommended.
Measurements shown in Figure 4 are in inches.
Figure 4. Mounting dimensions—top, side and end view
+
Recommended
case temperature
measurement
location
Breather Hole
Do not cover
or seal.
Mating surface flatness not to exceed 0.005 inches (0.127 mm)
DRIVE LENGTH W/SATA IS 3.951 + .008 / -.010 (WORST CASE)