Filter
Top Products
Momentus 5400.6 SATA Product Manual, Rev. E 23
3.4 Drive mounting
You can mount the drive using four screws in the side-mounting holes or four screws in the bottom-mounting
holes. See Figure 4 for drive mounting dimensions. Follow these important mounting precautions when mount-
ing the drive:
• Allow a minimum clearance of 0.030 in
ches (0.76 mm) around the entire perimeter of the drive for cooling.
• Use only M3 UNC mounting screws.
• Do not overtighten the mounting screws. Maximum torque: 4.0 inch-lb (0.4519 N-m).
• Four (4) threads (0.080 inches, 2.032 mm) minimum screw engagement recommended.
• Avoid excessive drive distortion when mounting. Refer to the
following specifications for stiffness/deflection
information:
Top cover stiffness/deflection
Operating with no performance degrad
ation, emitted noise,
mechanical damage, or hard errors
10 mm probe: 2.0kgf OR
5 mm probe: 0.92kgf
Non-operating with no hard errors 20 mm probe: 2kgf at any point of top cover
20 mm probe: 15kgf at top cover edges only