Seagate ST960814A Computer Accessories User Manual


 
38
Momentus 5400 FDE Product Manual, Rev. C
4.1.8 Set Features command
This command controls the implementation of various features that the drive supports. When the drive receives
this command, it sets BSY, checks the contents of the Features register, clears BSY and generates an inter-
rupt. If the value in the register does not represent a feature that the drive supports, the command is aborted.
Power-on default has the read look-ahead and write caching features enabled. The acceptable values for the
Features register are defined as follows:
Note. At power-on or after a hardware or software reset the default values of the features are as indicated
above.
Table 12: Features register values
02
H
Enable write cache (default).
03
H
Set transfer mode (based on value in Sector Count register).
Sector Count register values:
00
H
Set PIO mode to default (PIO mode 2).
01
H
Set PIO mode to default and disable IORDY (PIO mode 2).
08
H
PIO mode 0
09
H
PIO mode 1
0A
H
PIO mode 2
0B
H
PIO mode 3
0C
H
PIO mode 4 (default)
20
H
Abort, note supported
21
H
Abort, note supported
22
H
Abort, note supported
40
H
Ultra DMA mode 0
41
H
Ultra DMA mode 1
42
H
Ultra DMA mode 2
43
H
Ultra DMA mode 3
44
H
Ultra DMA mode 4
45
H
Ultra DMA mode 5
05
H
Enable advanced power management
55
H
Disable read look-ahead (read cache) feature.
82
H
Disable write cache.
AA
H
Enable read look-ahead (read cache) feature (default).
F1
H
Report full capacity available