Filter
Top Products
• 3 •
OPERATING INSTRUCTIONS4.
The Universal Power and Adapter Kit comes in a carrying case with 10
adapter plugs. Select the appropriate connector for the device you would
like to operate.
Setting the Converter Voltage 4.1
Determine the proper voltage setting by checking the electronic device •
rating plate, owner’s manual, or number of batteries.
Plugging Adapter Plugs into the Universal Power and Adapter Kit 4.2
and Electronic Device:
After selecting the appropriate adapter plug, push into the Universal Pow-•
er and Adapter Kit’s cord plug. NOTE: Each connector has a tab guide so
that they will only t into the plug one way. Forcing the connector into the
plug the wrong way (reversed polarity) will cause damage to your device
and/or Universal Power and Adapter Kit.
Make sure the electronic device is turned off. Firmly push the selected •
adapter into the device input socket.
Plugging Universal Power and Adapter Kit in Vehicle:4.3
Make sure that the 12V accessory (cigarette) outlet in your vehicle is free •
of any materials and debris. Particles in the accessory outlet could cause
a short; blowing the fuse in your vehicle and/or Universal Power and
Adapter Kit.
Make sure that the vehicle’s engine is off and there is not anything •
plugged into the Universal Power and Adapter Kit other than the selected
connector.
Firmly plug the 12V end of the Universal Power and Adapter Kit into the •
12V accessory outlet.
NOTE: Some vehicles’ 12V outlets are not live unless the key is turned
to the ACC position. If the red LED does not illuminate on the Universal
Power and Adapter Kit, turn the vehicle’s key to the ACC position without
starting the engine.
The Red LED illuminates when the Universal Power and Adapter Kit •
converter receives power from the 12V accessory outlet. The Universal
Power and Adapter Kit is equipped with a ve amp fuse, located in the
neck of the converter, for overload protection. See the Troubleshooting
section for instructions on how to replace the fuse.
Turn on the electronic device.•
It is not recommended to leave the Universal Power and Adapter Kit •
plugged into the vehicle’s 12V accessory outlet while the car is not run-
ning. Doing so may drain the vehicle’s battery.
WARNING: To ensure that damage will not occur, check voltage and
polarity of electronic device before using this product. ALWAYS SWITCH
OFF APPLIANCES PRIOR TO INSERTION OF PLUGS. Failure to do so
may cause damage that is not covered by the normal warranty. It is best to