Filter
Top Products
ENFORCER RACKMOUNT POWER SUPPLY
8 SECO-LARM U.S.A., Inc.
Troubleshooting:
Power does not turn on
Check front panel LEDs and rear main fuse.
Ensure the power cord is firmly in its socket.
Power cycles on and off
The unit may be overheating. Check for heat
sources nearby and ensure ventilation holes are
free from obstruction.
Voltage drop is large
Use 18 gauge or thicker wire.
The camera case is hot
Check that the correct power is being supplied.
Also Available:
Rack Mount Active
Balun Hub
EVT-AH16-VT2Q
Cut cost and complexity
by sending CCTV signals
over Cat5e/6 cables up to
8,000ft (2.4km).
ST-BT02Q
Perform 6 different tests
including voltage drop,
voltage with load,
polarity, and continuity
(LED only).
EVT-PB1-31RQ
Transmit video, power,
and data signals over a
single Cat5e/6 cable up
to 2,000’ (610m).
ST-LA110-TTQ
Converts 8~30 VAC/VDC
to a regulated 5/12/24
VDC output (adjustable).
12VDC Tester with
Continuity
Passive VPD Balun
1.0 Amp Voltage
Converter
CAUTION: To reduce the risk of electric shock, do
not open the product case. There are no user
serviceable parts inside. Refer servicing to qualified
service personnel.
Glass fuse models only: During replacement of
fuses, access fuses via unit front panel only. Use
caution when working with live electronic
equipment.
WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while used in normal
service for a period of one (1) year from the date of sale to the original consumer customer. SECO-LARM’s obligation is
limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM.
This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect,
repair, or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines
that such equipment is not operating properly as a result of causes other than defects in material and workmanship. The
sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to replacement or repair only, at
SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential
personal or property damages of any kind to the purchaser or anyone else.
NOTICE: The information and specifications printed in this manual are current at the time of publication. However, the
SECO-LARM policy is one of continual development and improvement. For this reason, SECO-LARM reserves the right
to change specifications without notice. SECO-LARM is also not responsible for misprints or typographical errors.
Copyright © 2010 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole
or in part, without the written permission of SECO-LARM.
SECO-LARM
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Tel: 800-662-0800 / 949-261-2999 Fax: 949-261-7326
Website: www.seco-larm.com
E-mail: sales@seco-larm.com
mi-PH-AXXXX-XUQ_0911.docx
PITSW1
Order Part # 764-504%