Filter
Top Products
40
Setup Parameter Values Description
LINE MODE LF=LF, CR=CR
CR=LF+CR
LF=LF+CR
LF&CR=LF+CR
If the printer receives a LF code (LF), it only performs a line feed. If
the printer receives a CR code (CR), it only performs a carriage
return.
If the printer receives a CR code (CR), it performs a carriage return
followed by a line feed. If the printer receives a LF code (LF), it
performs a line feed.
If the printer receives a LF code (LF), it performs a line feed followed
by a carriage return. If the printer receives a CR code (CR), it only
performs a carriage return.
If the printer receives a LF code (LF) or a CR code (CR), it performs
both a line feed and a carriage return.
WRAP MODE truncate, autowrap The data exceeding the line length are truncated (
truncate
) or
printed on the following line (
autowrap
).
SLASHED ZERO no, yes Selects the printing character for zero, with a slash (
yes
) or without
(
no
).
PRINT DIRECTION unidir., bidir.,
sw control
Selects the printing direction of the print head: unidirectional
(
unidir
.), bidirectional (
bidir
.) or selected via software (
sw
control
).
EJECT ON FF no, yes Performs a form feed according to the selected page format (
no
) or
ejects a cut sheet loaded into the printer (
yes
).
CUT SHEET EJECT on front, on rear Selects whether the cut sheet loaded into the printer is ejected
towards the front or the rear of the printer. The selection of the paper
ejection towards the rear of the printer should be selected only for
paper with a length of at least 14 cm (5,5 inch).