Filter
Top Products
Preparing the ADN PS power supply for use
8 | ADN PS
Preparing the ADN PS power supply
for use
Setting up the power supply
̈ Make sure that the air vents are not covered or blocked.
̈ Place the ADN PS power supply on a flat surface as shown.
Connecting the ADN PS power supply to the mains power supply
̈ First connect the mains cable (supplied) to the mains socket .
̈ Connect the mains cable to the mains power supply.
The ADN PS power supply is now ready for operation.
CAUTION
Danger of material damage and personal injury due to stacked
power supplies!
When stacking several ADN PS power supplies on top of each other,
• the stack may topple over,
• the temperature of the individual ADN PS power supplies may
drastically increase,
• high mechanical loading may be exerted on e.g. the housings,
cables or installation surfaces.
This can cause material damage and personal injury.
̈ Never stack several ADN PS power supplies on top of each other.
IFor information on how to mount the power supply into a 19” rack, refer to
the detailed instruction manual “ADN Conference System”.
CAUTION
Product damage due to unsuitable mains cables or power outlets!
An unsuitable power supply can damage the product.
̈ Use the mains cable (supplied) for connecting the product to the mains power
supply.
̈ Only use multi-outlet power strips or extension cables with protective ground
contacts.
̈ Only use mains cables with a 3-pin connector.
15
100 - 240V
50/60Hz 385W
C
C
KA_ADN-PS_543374_0911_SP13.book Seite 8 Mittwoch, 31. August 2011 12:23 12