Filter
Top Products
39
4
2
Place the original you wish to scan on the original table/SPF/
RSPF.
For the procedure for placing the original, see "ORIGINAL PLACEMENT"
(p.47).
3
Press the right copy quantity key to
display the number of the application that
you wish to use for scanning.
The application numbers are initially as follows.
4
Press the start ( ) key.
The selected application launches and scanning begins.
If the following screen appears, select Button Manager and click "OK". Button
Manager starts and the application associated with Button Manager starts. If you
want only Button Manager to start in this case, set up Button Manager for use in
Windows as explained in "Setting up the Button Manager" (p.34).
Opening the scanner driver and scanning from your computer
Follow the steps below to open the scanner driver setup screen. As an example, this
instruction is given using Sharpdesk as an image capture application.
Application
number
Application launched
SC1 Sharpdesk (if installed)
SC2
E-mail (your standard e-mail program in the
Windows OS you are using)
SC3 Fax (if a fax program is installed)
SC4 OCR (if an OCR program is installed)
SC5 Microsoft Word (if installed)
SC6 Any application set in Button Manager
• Scanning is not possible during a copy and print job.
• The method for starting the scanner driver differs depending on the
type of application. Refer to the manual or the help file of your
application.
• When using the scanner driver to scan an original that has been
placed in the SPF/RSPF. If you perform a pre-scan (see the online
manual or the help file for the scanner driver), the original in the SPF/
RSPF will be output to the exit area after scanning. To scan the
original after the pre-scan, place the original in the SPF/RSPF once
again.