Filter
Top Products
55
TROUBLESHOOTING
6
Copies are smudged or dirty.
The document glass or the underside of the document
cover/SPF/RSPF is dirty.
→ Clean regularly.
72
Original smudged or blotchy.
→ Use a clean original.
–
White or black lines appear on
copies.
The scanner glass in the SPF/RSPF is dirty.
→ Clean the long, narrow glass in the SPF/RSPF.
72
The transfer charger is dirty.
→ Clean the transfer charger.
73
Paper size for a paper tray cannot
be set.
Copying or printing is performed.
→ Set the paper size after copying or printing is complete.
–
The machine has stopped temporarily due to running out
of paper or a misfeed.
→ Load paper or remove the misfeed, and then set the paper size.
14, 64
An interrupt copy job is in progress.
→ Set the paper size after the interrupt copy job is finished.
31
The display or the ORIGINAL DATA indicator ( ) is
blinking.
→ Data is being held in memory. Print the data in memory or clear it
from memory.
33, 35
A copy job stops before it is
finished.
The paper output tray is full.
→ Long copy runs are automatically paused every 250 copies.
Remove the copies in the paper output tray and press the
[START] key ( ) to resume copying.
22
"FUL" appear in the display.
→ The memory became full during sort/group copy or 2 IN 1 / 4 IN 1
copy. Copy only the originals that have been scanned to that
point, or cancel the job and clear the data from memory.
33, 35
The tray is out of paper.
→ Load paper.
14
A paper feed location is blinking.
→ A blinking paper feed location means that the size of paper
loaded in the tray is different from the paper size setting for the
tray. Change the paper size setting, open and close the tray, and
then press the [CLEAR] key ( ) or [CLEAR ALL] key ( ).
16
The POWER SAVE indicator ( ) is
lit.
Any other indicators are lit.
→ If other indicators are lit, the machine is in "Preheat mode". Press
any key on the operation panel to resume normal operation.
12
The POWER SAVE indicator ( ) is only lit.
→ If only the POWER SAVE indicator ( ) is lit, the machine is in
auto power shut-off mode. Press the [START] key ( ) to
resume normal operation.
12
Any one of the alarm indicators
( , , , , ) is lit or
blinking.
See "INDICATORS AND DISPLAY MESSAGES" to check
the meaning of the alarm indicator and error message in
the display, and take appropriate action.
62
Lighting fixture flickers.
The same is being used for the lighting fixture and the
machine.
→ Connect the machine to a power outlet which is not used for other
electric appliances.
–
Problem Cause and solution Page
DATA