Filter
Top Products
13
DK-A1
DK-A1BK
Basic Operation
Setting the clock
In this example, the clock is set for the 12-hour (12:00 AM) display.
To confirm the time display:
[When the unit is in the stand-by mode
or in demonstration mode.
]
Press the CLOCK button to enter the clock function.
[When the power is on]
Press DISPLAY button on remote control to toggle between the
function information and clock display.
Notes:
The clock will continue counting for 8 hours should there be a
power failure or the AC power cord becomes disconnected.
The “CLOCK ADJ” will appear or time will flash to confirm the time
display when the AC power supply is restored after a power failure
or unplugging the unit after 8 hours. If incorrect, readjust the clock
as follows.
To readjust the clock:
Perform “Setting the clock” from step 1. Step 2 (selecting the 12-
hour or 24-hour display) will be skipped.
To change the 12-hour or 24-hour display:
Summer time:
The ST switch is located on the rear of the unit.
1 Press the CLOCK button for more than 2 seconds.
2 Press the or button to select 12-hour or 24-hour
display and then press the CLOCK button.
“12:00 AM” The 12-hour display will appear.
(12:00 AM - 11:59 PM)
“0:00 AM” The 12-hour display will appear.
(0:00 AM - 11:59 PM)
“0:00” The 24-hour display will appear.
(0:00 - 23:59)
3 Press the or button to adjust the hour and then
press the CLOCK button.
Press the or button once to advance the time by 1 hour.
Hold it down to advance continuously.
CLOCK
SNOOZE
DIMMER
AUX TUNERiPod
ALARM
ALARM
ON/OFF
4 Press the or button to adjust the minutes and then
press the CLOCK button.
Press the or button once to advance the time by
1 minute. Hold it down to change the time in 5-minutes interval.
1 Clear all the programmed contents. [Refer to “Clearing all the
memory (reset)” on page 23 for details.]
2 Perform “Setting the clock” from step 1.
1 Slide the ST switch to +1 to advance the time 1 hour.
indicator will appear.
2 Slide the ST switch to -1 to turn the clock back 1
hour.