Filter
Top Products
5-9
5
FINISHER
If the finisher is installed, the offset function can be used. Each set of printed sheets is stacked offset from the
previous set so that it can be easily taken out. Also each set of sorted sheets can be stapled.
Part names
NOTES
●
Do not put pressure on the finisher (particularly each tray).
●
Be careful about the offset tray during printing because the tray moves up and down.
●
Some other peripheral units may be needed for installation of the finisher and some peripheral units cannot be
installed together with the finisher. For combination of the peripheral units, see the list of combination of
peripheral units on page xxxx.
Specifications
Name Finisher
Number of trays 2
Exit system Print face down
Tray type Top tray: normal tray, Lower tray: offset tray
Paper capacity Top tray: 500 sheets (8-1/2" x 11" or A4 size, 20 lbs. or 80 g/m
2
)
Lower tray: 750 sheets (8-1/2" x 11" or A4 size, 20 lbs. or 80 g/m
2
)
Paper size Top tray: Max. 11" x 17" or A3, Min. 5-1/2" x 8-1/2"R or A5R
Lower tray: 8-1/2" x 11", A4 or B5R
Paper weight Top tray: 15 to 54 lbs. or 56 to 205 g/m
2
Lower tray: 15 to 34 lbs. or 56 to 128 g/m
2
Paper type Top tray: same as the specifications of paper for feeding in the main unit
Lower tray:
Paper limit detection Provided in both the top tray and the lower tray
Offset function Provided in the lower tray only, offset amount: 1.2 inch (30 mm)
Paper size for stapling 8-1/2" x 11", A4, and B5
Stapling capacity 30 sheets (20 lbs. or 80 g/m
2
)
Stapling position Three types (one at rear, one at front, two at center)
Reference paper position Center
Power supply Drawn from the power supply unit (peripheral unit)(See page xx.)
Dimensions xx-x/x” (W) x xx-x/x” (D) x xx-x/x” (H) (xxx mm (W) x xxx mm (D) x xxx mm (H))
Weight Approx. xxx lbs. (xx kg)
Specifications are subject to change for improvement without notice.
Supplies
For the finisher, the following staple cartridge is needed as supplies.
●
Staple cartridge (Approximately 3,000 staples x 3)
xxxx
Knob
Hold this knob to open the
finisher for misfeed removal.
Top cover
Open for misfeed
removal.
Staple unit
Pull out to replace the
staple cartridge or to
remove jammed
staples.
Top tray
Paper output from the
printer, copier, and fax
features can be
delivered here.
The tray is extendable.
To print onto large
paper (8-1/2" x 14", 11"
x 17", B4 or A3),
extend the tray.
Offset tray
The offset function and the
stapling function can be used
only in this tray.
Stapler compiler
Paper to be stapled is
stacked temporarily.