Filter
Top Products
30
Instructions for attaching a VESA-compliant arm
The following stand or arm can be attached to the
monitor.
- Stand (sold separately)
Model name: NL-S02-H (Ivory)
NL-S02-B (Black)
- VESA-compatible arm (commercially available)
Compatible commercially available arms
Attachments must satisfy the following.
- Compatible with the VESA standard.
- Have a gap of 100 mm x 100 mm between the
screw holes on the section to be attached.
- Not be likely to fall off or break off after being
attached to the monitor.
How to attach the arm or stand
- Be careful not to over bend the cable or add
extension cords as this could lead to malfunction.
- While following these instructions, please also
refer to the installation instructions in the
operation manual included with the arm or stand.
CAUTION!
- Be careful not to get your fingers pinched
between the display and stand nor to let the
stand drop. These could lead to injury.
1.Remove the cables.
2.Spread out a soft cloth on a suitable horizontal
surface.
3.Being careful not to damage the monitor, gently
lay the monitor on it display-side down.
4.Remove the four screws and then remove the
stand from the monitor.
Notes:
- The stand is specially made for use with this
monitor. Once having removed the stand, never
attempt to attach it to another device.
- Once having removed the screws, store them
together with the stand and if the stand is ever
re-attached be sure to use the original screws.
Using different screws could lead to a malfunction.
5.Attach the arm to the monitor with the four screws.
Note:
- The screws used to attach the arm should be M4
screws with a length of 6 - 8 mm protruding from
the surface to be attached. Using different
screws could cause the monitor to fall off or to be
internally damaged.
Screw used to attach arm
Arm
Part of monitor to which arm is
attached
03_191A_gb.P65 12/19/2003, 2:29 PM30