Sharp PG-D2710X Projector User Manual


 
-19
Setting and Adjusting the
Projector
(Settings & Adjustments)
Example:
“Picture” screen display for COMPUTER1
2
On these screens, you can make projector
settings or adjustments. You can set or
adjust the following items:
Controlling the Projector via LAN
Picture Mode
CLR Temp
BrilliantColor
TM
Film Mode
DNR
Eco + Quiet
Resolution Setting
Signal Type
Video System
Video Setup
Resize
Overscan
OSD Display
Background
Setup Guide
Projection Mode
Wall Color
OSD Language
Auto Sync
Auto Power Off
Auto Restart
Internal Speaker
RS-232C Speed
Fan Mode
Quick Start Menu
COMPUTER2 Select
DLP
®
Link
TM
DLP
®
Link
TM
Invert
All Reset
If you click the “Refresh” button before the
screen is displayed completely, an error
message (“Server Busy Error”) will be
displayed. Wait for a moment and then operate
again.
You cannot operate this page while the
projector is warming up.
For details about each item, refer to the
projector's operation manual.
Note
Setting the Security
(Network – Security)
On this screen, you can make settings
relating to security.
Items Description
User Name Setting of user name for security
protection.
Password Setting of password for security
protection.
Accept IP
Address
It is possible to set up to three IP
addresses allowing connection to the
projector.
All IP
Addresses
No limits are set to IP addresses
connecting to the projector.
From only
specifi c IP
addresses
For security improvement, only an IP
address set by “Address 1-3” can be
connected to the projector.
User Name and Password can be up to 8
characters.
You can input the characters below:
a-z, A-Z, 0-9, -, _
Note