Filter
Top Products
Setting Up and Using OpenLCR
49
2. Setting Up
OpenLCR
3
Enter a 2-digit number (01 to 29) for
the number of minutes of the SHORT
TIME setting. (If the number is less
than 10, enter a 0 before the number.)
The display will show your selection
and then show:
0 3
Example: 3 minutes
4
Enter a 2-digit number for the number
of minutes of the LONG TIME
setting. (The number must be greater
than the SHORT TIME setting and no
more than 30.)
The display will show your selection.
If the settings were changed, it will
then show:
0
Example: 5 minutes
5
START: DOWNLOAD
STOP: CANCEL
5
Press the START/MEMORY key to
begin receiving the rate data for the
new settings.
• Your fax calls OpenLCR and receives
the data. This lasts one or two
minutes.
• Note: If you do not press the START/
MEMORY key to receive new data,
the settings will revert to their
previous state.
START/MEMORY
Note: If the display shows NO
SERVICE, you must first
download the rate data.
LONG TIME
ENTER (03-30) 04
all.book Page 49 Wednesday, April 26, 2000 7:08 PM