Filter
Top Products
61
Useful
Features
Password
DHCP Client
Restart Network
TCP/IP
Disable
SEL./ADJ.
RETURN
ENTER
END
IP Address XXX.XXX.XXX.XXX
MAC Address XX:XX:XX:XX:XX:XX
Projector XX-XXXX
Picture Audio SIG SCR PRJ Net.
Off
Reset Network Setting
1
Setting a Password
If you do not want others to change the setting
for the “Net.” menu, set a password.
a
Setting a Password
1
Select “Password”, then press Q.
The screen for entering the password
appears.
Setting the Password
Old Password
New Password
Reconfirm
–
––––
–––
––––
Net.
2
Press P or R to set the fi rst digit
in “New Password”, then press Q.
3
Enter the remaining 3 digits, then
press ENTER.
To return to the previous digit, press O.
4
Enter the same password in
“Reconfi rm”, then press ENTER.
The status for “Password” changes to
“Enable”.
Once after the password is set, you must
enter the password to change the “Net.” menu
settings.
•
Note
•
•
•
1
2
3
4
a
Changing the Password
1
Select “Password”, then press Q.
The screen for entering the password
appears.
2
Enter the password in “Old
Password” using P, R, Q and O,
then press ENTER.
3
Enter the password in “New
Password” using P, R, Q and O,
then press ENTER.
4
Enter the same password again
in “Reconfi rm” using P, R, Q and
O, then press ENTER.
If you do not need the password protection for
the “Net.” menu settings anymore, press
ENTER without entering new password in
steps 3 and 4.
To cancel the password settings, press
RETURN.
•
•
Note
If you forget the password
If you forget the password, perform the
following procedure to delete it, then set a
new password.
On the projector, press
.
If ENTER is held down for more than 5
seconds, the operation buttons on the
projector will be locked. (See page
58.)
You cannot use the buttons on the
remote control to delete the password.
•
•
Note
•
1
2
3
4
Setting Up the Projector Network Environment (“Net.” Menu)
Menu operation n Page 46