Shure BLD5760 Electronic Accessory User Manual


  Open as PDF
of 4
 
GE Protimeter Aquant Page 3
2. Scroll across the display and record the following information:
a. part number
(“bLd5760”)
b. firmware date in the form yy-mm-dd (e.g
. “04-05-20”)
c. calibration code (e.g.
E1-1).
Note: Once the scrolling is complete, display shows “0 = 0” meaning that option 0 is set to 0. The
and buttons may now be used to change the instrument options and settings,
respectively, as detailed in Table 1 below.
Note: The instrument options can only be changed in numerical order (0, 1, and 2 respectively).
Save setting changes and exit the Set-up mode by pressing again, as in Step 4 of the
following example:
Example:
To switch the audible beeper
OFF and set the auto switch OFF time to 3 minutes, complete the
following steps:
1. Press and hold
followed by to enter Set-up mode.
2. When display shows 0 = 0, press once to select beeper options (1), then press
until the
display shows 1 = 0.
TABLE 1. User Set-Up Options
When
Option No. Is:
And Setting
Number Is: Aquant Set-Up Is:
0 0 Instruments settings are not changed from previous settings
1 Instrument default settings loaded - switches OFF
automatically after 1 minute, beeper is activated, factory-set
zeroing
1 0 Beeper is switched OFF
1 Beeper beeps when switching from one mode to the other
2 Beeper beeps with increasing frequency from nominal value
of 170
2 0 Auto switch OFF is not active. Instrument can only be
switched OFF by pressing and holding it for over 3 sec.
1 Auto switch OFF is active. Instrument switches OFF after 1
minutes
2 Auto switch OFF is active. Instrument switches OFF after 2
minutes
3 Auto switch OFF is active. Instrument switches OFF after 3
minutes
 previous