Filter
Top Products
SLP 410
Do not use
both cables
or
SLP 420/430/440/450
Label guides
Preparing the SLP
1 Install the software, then connect the printer to your PC or Mac.
• The SLP can be connected to either the Serial or USB port on
your PC. Do not use both cables. On your Mac use the USB port.
• Connect the other end of the cable into
the appropriate port on the back of the SLP.
2 Connect the supplied AC adapter to the
back of the SLP and to a power outlet.
3 Press the button to turn the printer on.
The status light will flash until the labels are loaded.
4 Lift the label cover.
5 Load a roll of standard labels.
• Remove the sticker from the roll, and then place
the roll on the spindle as illustrated. If using an
SLP 420, 430, 440 or 450, adjust the label guides
to fit against the roll.
• Feed the labels into the slot on the back of
the printer. The labels automatically feed to
the exit slot, then stop.
• Close the label cover.
6 Start your SLP software and begin using your
new SLP. If you want to run a test label, please
refer to the FAQ “Test Labels” on our website:
www.siibusinessproducts.com.