Filter
Top Products
4
5. Slide the Dual 2.5" SATA MobileRack into the drive
bay and secure it on each side using the mounting
screws.
6. Connect a power cable to the power connector that
is matched with your system's power supply or use
the supplied power adapter cable.
7. Connect one end of the Serial ATA cable to the Dual
2.5" SATA MobileRack and the other end to the
motherboard SATA port. Please repeat these steps
if you are installing the second hard drive.
8. Close your computer case.
Installing the Hard Drive into the MobileRack
1. Unlock upper and lower covers, then open the
door (see Figure 3 on the next page).
Note: Do not force the door to open while it is
locked. Otherwise, you will damage the lock.
2. Place one or two hard drive(s) in the slot. Make sure
the SATA connector is lined up with the connector
inside the MobileRack.
3. Carefully push the hard drive into the MobileRack
so that the drive's SATA connector is seated securely,
then close the door and lock it.
Note: It must be in the lock position when in use.
This prevents unexpected removal while working.