Filter
Top Products
7
5. Slide the lower cover back into the case and
secure it with the two mounting screws,
then slide the upper cover back into the case
and secure it with the two mounting screws.
6. Plug the included USB 3.0 cable into the
enclosure. (Use the cable end with the single
Type A USB connector).
7. Plug the USB Data Connector, see Figure 2
on page 3, into a USB port of the computer.
Important:In most cases the USB Data
Connector will supply enough power to
the enclosure. If not, use the optional USB
Power Connector to supply more power.
Before proceeding, first unplug the USB
Data Connector, then plug the USB Power
Connector into an available USB port,
then re-plug the USB Data Connector.
8. The SuperSpeed USB 3.0 to SATA 2.5"
Enclosure will turn on automatically. Make
sure that the LED is lit.
Go to Driver Installation to complete the
installation.