Filter
Top Products
8
5. Slide the lower cover back into the case and secure it
with the two mounting screws, and followed by upper
cover.
6. Plug the included USB 3.1 cable into the enclosure. (Use
the cable end with the single Type A USB connector.)
7. Plug the USB Data Connector, see Figure 2 on page
4, into a USB port of the computer.
8. The USB 3.1 to SATA 2.5 External Hard Drive Enclosure
will turn on automatically. Make sure that the LED is
lit.
9. Windows and Mac will automatically detect and
install drivers for the enclosure, it is ready for use.
Note: In most cases the USB Data Connector will
supply enough power to the enclosure. If not, use the
optional USB Power Connector to supply morepower.
Before proceeding, first unplug the USB Data
Connector, then plug the USB Power Connector into
an available USB port, then re-plug the USB Data
Connector.