Filter
Top Products
Chapter 2
Connecting the Adapter to a Network
To install the SGI 10-Gbit Ethernet network adapter, refer to the instructions for
installing a PCI card in the user’s or owner’s guide that came with the SGI system.
To connect the adapter to a network, do the following:
1. Remove the protective end caps and save them.
!
Caution: 10-Gbit optics are very sensitive. If you plan on leaving them
disconnected for any length of time, you must replace the end caps. The optics on
the SGI 10-Gbit Ethernet network adapter cannot be cleaned.
2. Insert the LC connector on one end of the fiber-optic cable into the adapter, as
shown in Figure 2-1. Ensure that the connector is inserted completely into the jack.
Note: If the network connects to an Ethernet switch, consult the operating
manual for the switch to ensure that the switch port is enabled and configured
correctly and as the correct adapter type (10GBASE-SR).
3. Insert the connector on the other end of the fiber-optic cable into the connector on
the Ethernet switch, or another computer system (as appropriate).
Figure 2-1 and Figure 2-2 show the connectors for the Release 1 and Release 2 cards.
(The Release 2 card is supported with SGI ProPack 4 SP 3 and later releases.)
007–4669–003 5