Filter
Top Products
Page 33 of 74
intelligent wireless platform
airClient™ TOTAL 3416 User Guide
3. Enter the IP address and Subnet mask to set the IP address and subnet mask, and any
Gateway Address if required. Assign the unit a unique IP Address in the designated IP subnet.
4. Click on Save to save the changes. The settings will be applied after the reboot.
Figure 2-19 airClient TOTAL Bridge LAN Settings (sB3416-03 Only)
Radio Settings
Follow the steps below to configure the Radio parameters in the airClient TOTAL Bridge Mode, for
Transparent bridging :
1. From the navigation menu bar, click on Radio | Wireless Settings to set the radio parameters.
The Wireless Settings screen will be displayed as shown in Fig 2-20.
2. Set the SSID, and the wireless mode to 802.11a.
3. The Remote AP MAC Address should be set to 00:00:00:00:00:00. (Note: This setting
differentiates the Client Bridge mode from the WDS bridge mode, when IP Mux is Disabled).
4. The Channel field should be set to SmartSelect in this mode. (Note: The channel in
SmartSelect setting will follow the channel of the Access Point, it is associated with.)
5. For the Antenna Selection, choose either Internal or External antenna, as per the requirement.
6. Select the Country for the domain settings.
7. Configure the Distance parameter to configure the Ack Window.
8. Select the Data Rate from the drop down menu. By default, the data rate is set to Best.
9. Set the Default Data Rate to set the data rate for transmitting beacons, broadcast and multicast
traffic. By default, this rate is set to 1 Mbps.
10. Select the Transmit power of the radio from the drop down menu.
11. Select the Preamble to be Long or Short. By default the preamble is set to Long.
12. Click on Save to reboot and for the settings to take effect. The unit will attempt to associate after
the Reboot.