Filter
Top Products
Command Line Interface
4-66
4
Example
This example shows the information displayed by the whichboot command. See
the table under the dir command for a description of the file information displayed by
this command.
boot system
This command specifies the image used to start up the system.
Syntax
boot system [unit:] {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom - Boot ROM.
• config - Configuration file.
• opcode - Run-time operation code.
The colon (:) is required.
filename - Name of the configuration file or image name.
unit - Specifies the unit number.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified file type.
• If the file contains an error, it cannot be set as the default file.
• A colon (:) is required after the specified unit number.
Example
Related Commands
dir (4-64)
whichboot (4-65)
Console#whichboot
file name file type startup size (byte)
-------------------------------- -------------- ------- -----------
D2.2.1.3 Boot-Rom image Y 169740
V2.2.1.9 Operation Code Y 1635684
Factory_Default_Config.cfg Config File Y 5013
Console#
Console(config)#boot system config: startup
Console(config)#