Filter
Top Products
12
1.2 | Resetting the Wireless Ethernet Adapter
To reset the SMC2670W Wireless Ethernet Adapter or to correct
temporary connectivity problems,follow the steps outlined
below:
1. Locate the [Default] button on the back of the EZ Connect
Wireless Ethernet Adapter.
2. Unplug the power from the back of the Wireless Ethernet
Adapter for 5 seconds.
3. Hold down the [Default] button, located on the back of
the device.
4. Plug the power connector into the Wireless Ethernet
Adapter while holding down the [Default] button.
5. Release the [Default] button after 3 seconds.
6. Wait another 3 seconds,and then push and hold down the
[Default] button again.
7. The "LNK/ACT" and "TX/RX" LED indicators will blink once
per second about 10-12 times.
8. When the LED indicators begin flashing rapidly,release the
[Default] button.