B
ASIC
C
ONFIGURATION
3-47
Command Usage
• The startup configuration file maps configuration settings to each switch
in the stack based on the unit identification number. You should
therefore remember to save the current configuration after renumbering
the stack.
• For a line topology, the stack is numbered from top to bottom, with the
first unit in the stack designated at unit 1. For a ring topology, the Master
unit taken as the top of the stack and is numbered as unit 1, and all other
units are numbered sequentially down through the ring.
Web – Click System, Renumbering.
Figure 3-21 Renumbering the Stack
CLI – This example renumbers all units in the stack.
Resetting the System
Web – Click System, Reset. Click the Reset button to restart the switch.
When prompted, confirm that you want reset the switch.
Figure 3-22 Resetting the System
CLI – Use the reload command to restart the switch.
Note:When restarting the system, it will always run the Power-On
Self-Test.
Console#switch all renumber 4-34
Console#
Console#reload 4-30
System will be restarted, continue <y/n>?