SonicWALL (PoE)Injector Switch User Manual


  Open as PDF
of 2
 
Safety Information (continued)
WARNING
Read the installation instructions before connecting
the PoE Injector to its power source.
WARNING
Follow basic electricity safety measures whenever
connecting the PoE Injector to its power source.
WARNING
This product relies on the building installation for
short-circuit (over current) protection. Ensure that a
fuse or circuit breaker no larger than 120 VAC, 3A.
U.S. (240 VAC, 1.5A international) is used on the
phase conductor.
WARNING
A voltage mismatch can cause equipment damage
and may pose a fire hazard. If the voltage indicated
on the label is different from the power outlet voltage,
do not connect the PoE Injector to this power outlet.
WARNING
The PoE Injector "Data In" and "Data & Power Out"
ports are shielded RJ-45 data sockets. They cannot
be used as Plain Old Telephone Service (POTS)
telephone sockets. Only RJ-45 data connectors may
be connected to these sockets.
SonicWALL, Inc.
1143 Borregas Drive
Sunnyvale, CA 94089-1306
T: +1.408.745.9600
F: +1.408.745.9300
www.sonicwall.com
© 2004 SonicWALL, Inc. is a registered trademark of
SonicWALL, Inc. Other product and company names mentioned
herein may be trademarks and/or registered trademarks of their
respective companies. Specifications and descriptions subject to
change without notice.
P/N: 232-000537-00
Rev. A 04/04
SonicWALL
Power over Ethernet
(PoE) Injector
User’s Guide