Sony BM-845D Microcassette Recorder User Manual


 
14
Operations
Transcription (continued)
Auto backspace function
This control operates only when the foot control unit is connected.
With the use of the REVERSE TIME control, the tape is rewound a little
each time it is stopped. Then, the last few recorded words can be reviewed
when you resume listening. Adjust the REVERSE TIME control to
determine the length of tape to be rewound.
At “9” position, the tape is rewound so that the dictated material can be
reviewed for about 5 seconds*. At “0” position, the tape stops without
being rewound at all.
Set the REVERSE TIME control to the desired position and keep the right
side of the pedal depressed to listen to the tape.
* Measured at some point near the middle of the tape. The reverse time will vary in
accordance with the remaining length of the tape.
Tape transport operation
To BM-845 Hand control unit Foot control unit
Rewind Press 0 REW. Keep the function Keep the left side of the
selector pressed down pedal depressed.
toward B.SPACE.
Stop Press p STOP. Set the function Release the pedal.
selector to STOP.
Listen Press ( Set the function Keep the right side of
LISTEN. selector to LISTEN. the pedal depressed.
Fast Press ) FF. Keep the FWD SPACE Keep the top center of
forward button pressed. the pedal depressed.
Private listening
Connect a Sony DE-45 or MDR-U10M earphones (not supplied) to the
EARPHONE jack. The sound will be heard through the earphones and
speaker sound will be disconnected.
Selecting the speaker
You can listen to the dictated material through the built-in speaker or the
speaker on the hand control unit by switching the SPEAKER selector to
BUILT-IN or HAND.
REVERSE TIME : at “9” position
Next playback will start from this point.
approx. 5 seconds
STOP is pressed at this point.
Tape
Playback
playback
REVERSE TIME : at “0” position
STOP is pressed at this point.
Next playback will start from this point.
playback
Playback
Tape
Note
If the LTR or SEC signal is
detected while the tape is being
rewound with this function, the
length of the reverse time may
be longer than the setting you
have selected.