Filter
Top Products
3
EN
Table of Contents
Installation
• Prevent internal heat buildup by allowing adequate air
circulation. Do not place the unit on surfaces (rugs,
blankets, etc.) or near materials (curtains, draperies) that
may block the ventilation holes.
• Do not install the unit near heat sources such as radiators
or air ducts, or in a place subject to direct sunlight,
excessive dust, mechanical vibration or shock.
• Do not place the unit near equipment that generates
magnetism, such as a converter or high-voltage power
lines.
Maintenance
Clean the cabinet, glass panel, and controls with a soft cloth,
lightly moistened with a mild detergent solution. Do not use
any type of abrasive pad, scouring powder, or solvent, such
as alcohol or benzine.
Warning on Power Connection
• Use the supplied power cord.
Getting Started
Before using this monitor, make sure that the following
items are included in your package:
the monitor, power cord and this operating instruction
manual.
This monitor will sync to platforms running at horizontal
frequencies between 31.5 and 64 kHz.
Connecting the Computer
Step 1: With the monitor switched off, attach the power
cord to the monitor and then to the power outlet.
Step 2: With the computer switched off, attach the video
signal cable to the video output.
Step 3: Turn on the monitor and computer.
Step 4: If necessary, adjust the user controls according to
your personal preference.
The installation is complete.
Computer
to the video output
for 220 to 240 V AC
for 100 to 120 V AC
For the customers in U.S.A.
If you do not do this, this monitor will not conform to
mandatory FCC standards.
• Before disconnecting the power cord, wait for at least
30 seconds after turning off the power switch to allow for the
discharging of static electricity on the CRT display surface.
• After the power has been turned on, the CRT is
demagnetized for approximately 5 seconds. This,
generates a strong magnetic field around the bezel, which
may affect the data stored on magnetic tape or disks near
the bezel. Place such magnetic recording equipment and
tapes/disks at a distance from this unit.
The socket-outlet shall be installed near the equipment
and shall be easily accessible.
Precautions
Power cord (supplied)
to the power
outlet
Precautions ............................................................................... 3
Getting Started ......................................................................... 3
Adjustments.............................................................................. 4
Power Saving Function........................................................... 5
Plug and Play ........................................................................... 6
Damper Wire ..........................................................................6
Use of the Tilt-Swivel ............................................................6
Specifications ..........................................................................6
Troubleshooting .....................................................................7