Filter
Top Products
47
Replacing the Lamp
Maintenance
• Be careful not to touch the glass surface
of the lamp.
• The power will not turn on if the lamp is
not secured properly.
6 Restore the lamp cover to the original
position and tighten the three screws
with the Phillips screwdriver.
Be sure to attach the lamp cover securely
as it was. If not, the projector cannot be
turned on. (Page 51)
7 Connect the power cord.
The ON/STANDBY indicator lights in
red.
8 Press the ?/1 key to turn the projector
on.
9 Press the MENU key, and then select
the Setup menu.
10Select “Lamp Timer Reset”, and then
press the ENTER key.
11Select “Execute” with the V key, and
then press the ENTER key.
The Lamp Timer is initialized to 0, and
“Change the Lamp and clean the Filter?”
is displayed in the menu screen.
Refer to page 48 for “Cleaning the Air
Filter”.
12Select “Yes” with the v key.
“Lamp Timer Reset Complete!” is
displayed in the menu screen.
To erase a message, press any key on the
control panel of the projector or on the Remote
Commander.
Notes
Note
Note
Disposal of the used lamp
For the customers in the USA
Lamp in this product contains mercury.
Disposal of these materials may be
regulated due to environmental
considerations. For disposal or recycling
information, please contact your local
authorities or the Electronic Industries
Alliance (www.eiae.org).
Change the Lamp and clean the Filter?
Yes:
No: