Filter
Top Products
Adjustment Using the Menus
20
USER CONFIG menu
The USER CONFIG menu is used for setting the
system, marker, WFM/ALM display, function button,
and audio.
SYSTEM SETTING
PICTURE CONTROL Adjusts the picture.
• ACC (Auto Color Control):
Sets ACC circuit on or off.
To check the fine
adjustment, select OFF.
Normally select ON.
• CTI (Chroma Transient
Improvement): When a low
color resolution signal is
input, a crisp image can be
displayed. When the setting
is higher, the picture
becomes even more crisp.
• V SHARPNESS: A crisp image
can be displayed. When the
setting is higher, the picture
becomes even more crisp.
INPUT SETTING • SHIFT H: Adjusts the position of
the picture. As the setting
increases, the picture moves
to the right, and as the
setting decreases, the picture
moves to the left.
• SHIFT V: Adjusts the position of
the picture. As the setting
increases, the picture moves
up, and as the setting
decreases, the picture moves
down.
Submenu Setting
SYSTEM SETTING:
MARKER SETTING:
WFM/ALM DISPLAY SETTING:
FUNCTION BUTTON SETTING:
AUDIO SETTING:
USER CONFIG
NTSC SETUP: xxxxxx
FORMAT DISPLAY: xxxxxx
LANGUAGE: ENGLISH
POWER SAVING: xxxxxx
I/P MODE: xxxxxxx
LED BRIGHTNESS: xxxxxx
RGB RANGE: xxxxxx
SCREEN SAVER: xxxxxx
USER CONFIG – SYSTEM SETTING
Submenu Setting
NTSC SETUP Selects the NTSC setup level from
two modes.
The 7.5 setup level is used mainly
in North America. The 0 setup level
is used mainly in Japan.
FORMAT DISPLAY Selects the display mode of the
signal format and scan mode.
• OFF: The display is hidden.
• AUTO: The format and scan
mode are displayed for
about 10 seconds when the
input of the signal starts.
LANGUAGE Selects the menu or message
language from among seven
languages.
• ENGLISH: English
• FRANÇAIS: French
• DEUTSCH: German
• ESPAÑOL: Spanish
• ITALIANO: Italian
• : Japanese
•: Chinese
POWER SAVING Sets the power saving mode on or
off. When you set to ON, the
monitor goes into power saving
mode if no signal is input for about
one minute.
I/P MODE (picture delay
minimum)
Selects to set the delay by the
picture processing to the minimum
level when the interlace signal is
input.
• INTER-FIELD: Mode for
giving precedence to the
picture quality. Performs
interpolation depending on
the movement of the images
between the fields. It takes
longer than “FIELD
MERGE” or “LINE
DOUBLER” for processing
the picture. “INTER-
FIELD” is the factory
setting.
• FIELD MERGE: The
processing time is shorter.
Combines the lines in the
odd fields and even fields
alternately regardless of the
movement of images.
Suitable for viewing still
images.
• LINE DOUBLER: The
processing time is shorter.
Performs interpolation by
repeating each line in the
data receiving sequence
regardless of the field. As
the line flicker is displayed
in this mode, it is available
for checking the line flicker
of the telop work and so on.