Filter
Top Products
SFM1
Installation Manual Page - 13 -
Securing the Flat Panel to the Wall Mount
WARNING: At least (2) qualified personnel are strongly recommended for installation of this product. Failure
to do so could result in serious injury and possible damage to the flat panel.
1. Raise the flat panel with the LEFT and RIGHT mounting brackets secured to the flat panel and insert the
top hooks from each bracket to the rod on the wall plate (Figure 13).
Figure 13. Securing The Flat Panel
Lateral Shift Adjustment
1. Make any lateral shift adjustment and lock it by tightening the two (2) ¼”-20 Phillips screws found on the
bottom of the mounting brackets (Figure 14).
2. Use the foot leveler to adjust your plasma.
CAUTION: Do not over tighten the ¼”-20 screws to the rods.
Figure 14. Lateral Shift Adjustment
Wall Plate
TOP
BOTTOM
Lateral Shif
t
¼ - 20” Screw
Leveling Foot