Filter
Top Products
9.To install a memory module, insert the module into an expansion slot at an angle and
then push it down until it clicks into place. To be certain that the module is installed cor-
rectly, ensure that the off-center notch on the module is aligned with the off-center key
of the expansion slot. The module can only be installed one way due to the position of
the notch.
10. Return the keyboard panel back to its original position and be sure both keyboard
locking tabs have been secured. Close the display screen and secure the single holding
screw on the bottom panel of the computer.
11. Insert the battery back into its compartment and turn the system right side up.
12. Replace the AC power supply and any other cables you may have disconnected.
13. Open the display screen and turn the system on. The computer will automatically
reconfigure itself to recognize the additional memory. The new memory can be verified
during the POST routine at start-up and at the SETUP utility.
The installation is now complete.
WARRANTY & DISCLAIMERS:
All Viking Components products have been thoroughly tested free of defects in material
and workmanship. If any malfunction should occur while using one of our products in its
recommended environment,Viking,at its option, will repair or replace the product at no
charge,provided the product or any part thereof has not been abused, misused,neglect-
ed, replaced, repaired or modified. Viking shall make the final determination as to the
existence and the cause of any defect. Viking will not repair or replace products desig-
nated as having a “Limited Lifetime” which fail solely because their estimated life has
expired. No warranty is made with respect to customer products produced to original
purchaser specifications except as specifically stated in writing by Viking.
All shipping costs shall be the responsibility of the purchaser.
Except as provided herein, there are no express or implied warranties of merchantability
or fitness for a particular purpose. Under no circumstances will Viking Components be
liable in any way to the purchaser for any damages,including but not limited to lost rev-
enue,lost wages,or any other incidental or consequential damages arising out of the use
of or inability to use this product. Viking reserves the right to make modifications in both
hardware and software without prior notifications.
All Viking Components products are 100% guaranteed compatible with the OEM
machines for which they are designed. All OEM's names, trademarks and part numbers
are used for identification purposes only, and in no way imply that any of our products
are original equipment parts.
Sony and VAIO are registered trademarks of Sony Corporation.
Product names mentioned herein may be trademarks or registered trademarks of their
respective companies.
Copyright 2000 Viking Components, Inc.
2