Filter
Top Products
20
Connecting the Projector
• Be sure to use the HDMI cable with an
HDMI logo.
• The HDMI connector of this projector is not
compatible with DSD (Direct Stream
Digital) Signal or CEC (Consumer
Electronics control) Signal.
This section describes how to connect the
projector to a VCR.
For more information, refer to the
instruction manuals of the equipment you
are connecting.
To connect to a video or S video
output connector
1 Stereo audio connecting cable (not supplied)
(Use a no-resistance cable.)
2 Video cable (not supplied) or S-Video cable
(not supplied)
For stereo audio connection, connect the stereo
audio connecting cable to following
connectors:
VPL-EX70/EX7: AUDIO INPUT connector
VPL-EW7: VIDEO IN AUDIO connector
To connect to a video GBR/
Component output connector
1 Signal Cable (not supplied)
HD D-sub 15-pin (male) ↔ 3 × phono jack
2 Stereo audio connecting cable (not supplied)
(Use a no-resistance cable.)
• For stereo audio connection, connect the
stereo audio connecting cable to following
connectors:
VPL-EX70/EX7: AUDIO INPUT connector
VPL-EW7: INPUT A AUDIO connector
• Set the aspect ratio using “Aspect” on the
INPUT SETTING menu according to the
input signal.
Notes
Connecting a VCR
VCR
to S
video
output
Rear side
to audio
output (R)
to video
output
to audio
output (L)
VPL-EX70
Note
Notes
Rear side
VCR
to video
GBR/
component
output
VPL-EX70
to audio
output (R)
to
audio
output
(L)