Filter
Top Products
SpectraLink Corporation Installation, Configuration, and Administration
NetLink SVP Server (within IP environments)
PN: 72-0178-01-F.doc Page 23
Alias IP Addresses are not necessary in Cisco systems.
Enable H.323 Gatekeeper
In certain H.323 protocol systems, the SVP Server may function as a gatekeeper.
Enter Y to have the SVP Server function as the gatekeeper in the H.323 protocol
environment.
Ethernet link
The SVP Server will auto-negotiate unless there is a need to specify a link speed.
System Locked
This option is used to take the system down for maintenance. The default entry
is N (No). Set it at Y (Yes) to prevent any new calls from starting. Return to N to
restore normal operation.
Maintenance Lock
The system automatically sets this option to Y (Yes) after certain maintenance
activities that require reset, such as changing the IP address. Maintenance Lock
prevents any new calls from starting. Note that the administrator cannot change
this option. It is automatically set by the system. Reset the system at exit to clear
Maintenance Lock.
Inactivity Timeout (min)
Set the number of minutes the administrative module can be left unattended
before the system closes it. This number can be from 1 to 100. If it is set to zero
(0), the administrative module will not close due to inactivity.
QoS Configuration
Select this option to set the DSCP tags. See
QoS Configuration
section below.
Reset System
If this option is selected, you will be prompted to reset the NetLink SVP Server
upon exiting this screen.
Reset All SVP Servers
If this option is selected, you will be prompted to reset all SVP Servers upon
exiting this screen. This is necessary if you have changed configurations on other
SVP Servers by using the SendAll option.
The NetLink SVP Server should be reset at the end of any maintenance
procedure that requires a reset either via
Maintenance Lock or manually
via Reset System.
Note that resetting the NetLink SVP Server will terminate any calls in
progress.